Wall and Floor Membrane Products

Buy Direct

 
 
Ring us with your order or for FREE Technical Help - 01626 331351
Click to go to Home Page   
 

 

Floor & Wall Membranes - Wall Plaster Membranes - Plugs & Seals

        Technical Help

--SECURE PROCESSINGSEcure ProcessingSECURE PROCESSING

Tapes - Masonry Drill Bits - Sumps - Pumps - Channels - RH Monitors
 
     


    
Floor and Wall Membrane - 2 metres x 20 metres - part rolls available  
    
 

Easy to lay as a floor membrane, over damp concrete, slabs, slates or well compacted earth. Simply roll out and join with the self amalgamating, double sided Joint Tape. Press the two sheet edges together with an overlap of 3 - 4 stud rows (about 75mm), stud side down. You can lay a concrete floor or screed directly on top, or fit a 'floating' floor of tongued and grooved chipboard. As a wall membrane the sheets are hung from the top, using the black hammer in plugs, which have a hole in the middle ready to take a number 12 self tapping screw. Each plug is fitted with a waterproof seal washer. Battens are then screwed to the plug heads. Usage rate - a roll, 2 metres wide x 20 metres long will cover about 36 square metres, allowing 10% for the overlapping joints. Allow 4 plugs per square metre. Data Sheet - click here.

Complete Kits include - Membrane, Black Plugs, Black Plug Seals, Joint Tape.

Frequently purchased with this product - 10mm Masonry Bit, Joint Tape, Black Plugs, Black Plug Seals, Corner Tape, Mastic Sealant, Sump and Pump, Aquachannel Drain, Drainage Outlet, Jetting Eye, Profile Strip (Ventilated Edging).

Roll of Membrane laid onto a floor - no fixings required

 
  
 
 

£220 Membrane per roll of 40 square metres, no fixings, or £20 cutting charge for part rolls, plus VAT.

Complete Kits, with all fixings, giving you a 15% discount, also available as follows:

40 square metres £381.77, 20 square metres £207.88, 10 square metres £129.34, plus VAT.

 

Profile Strip Ventilated Edging - provides a neat 10mm vent gap

 
    
 

Roll of Membrane only (non-mesh type, no fixings) 40 sq.m.

Profile Strip (ventilated edging) 2 metre length

Complete Kits, with plugs, seals, tape: discounted packages -

40 sq.m

20 sq.m.

10 sq.m.

 

Membrane Kit Contents - Membrane, Tape, Plugs, Seals

 

 
 

 
Wall Plaster Mesh Membrane - 2 metres x 10 metres - part rolls available  
 

 

As a wall membrane only, the sheets are hung from the top, using the white hammer in plugs, which have a rough top surface to take plaster. Each plug is fitted with a waterproof seal made from a roll of mastic rope, or by using the special mastic sealant. The Mesh surface can be either directly plastered with Bonding or covered with Plasterboard on dabs of adhesive. Plastering can be carried out using Carlite Bonding Plaster. Usage rate - a roll, 2 metres wide x 10 metres long will cover about 18 square metres, allowing 10% for the overlapping joints. Allow 25 plugs per square metre for plastering, or 10 plugs per square metre for plasterboard 'dabs'. Data Sheet - click here.

Complete Kits include - Mesh Membrane, White Plugs, Mastic Rope, Joint Tape.

Frequently purchased with this product - 8mm Masonry Bit, Joint Tape, White Plugs, Mastic Rope (for plug Seals), Mastic Sealant, Profile Strip (Ventilated Edging).

 

Plaster Mesh Membrane - white plug being hammered in.

 
 

£150 Mesh Membrane per roll of 20 square metres, no fixings, or £20 cutting charge for part rolls, plus VAT.

Complete Kits, with all fixings, giving you a 15% discount, also available as follows:

40 square metres £515.37, 20 square metres £257.69, 10 square metres £168.67, plus VAT.

 

Profile Strip Ventilated Edging - provides a neat 10mm vent gap

 
    
 

Roll of Mesh Membrane (no fixings) - 20 sq.m.

Profile Strip (ventilated edging) 2 metre length.

Complete Kits, including plugs, seal rope and tape, discounted packages:

40 sq.m.

20 sq.m.

10 sq.m.

Mesh Membrane with Kit Contents - Mastic Rope, Plugs, Tape

 
 

 
Black Plugs - for fixing non-mesh type Membrane to walls - for use with battens  
 

The black plugs are 11mm in diameter and 73mm long. They require a 10mm masonry bit. Rubber seals need to be fitted, cone face outwards. The 10mm diameter holes should be drilled at least 85mm deep, to allow for drill dust, so that the seal is pushed into the dimple properly. Usage rate - 4 plugs per square metre, 600mm maximum spacing allow battens, battens spaced to suit the plasterboard chosen.

Frequently purchased with this product - Black Plug Seals (pack of 100), 10mm Masonry Bit, Mastic Sealer (400cc tube), for sealing holes drilled through the Membrane that will not take a plug.

£49.87 per pack of 100, plus VAT.

 

Blacks Plugs, one with self tapping screw. Cone faced seal ready to fit.

 

 

 


 

 
 
Black Plug Seals - special, soft rubber cone faced washers  
 

For sealing between the black plug head and the dimple in the Membrane. The cone face is fitted outwards, under the plug head, to fit the cone shaped stem. Usage rate - 1 per plug, 4 per square metre.

Frequently purchased with this product - Mastic Sealer (400cc tube), for sealing holes drilled through the Membrane that will not take a plug.

£26.50 per pack of 100, plus VAT

Black Plug Seals - pack of 100 .

Mastic Sealer - 400cc cartridge

 

Hammering in a black plug and a black plug with seal washer fitted

 


 
 

White Plugs - for fixing mesh type Plaster Membrane to walls

For fixing mesh membrane. The plugs are 10mm diameter x 70mm long. They require a 8mm diameter hole drilled to at least 80mm deep, to allow for bore dust. Usage rate - Allow 25 plugs per square metre for plastering, or 10 plugs per square metre for plasterboard 'dabs'.

Frequently purchased with this product - 8mm Masonry Bit, Mastic Rope, Mastic Sealer (400cc tube), for sealing holes drilled through the Membrane that will not take a plug.

£49.73 per box of 250, plus VAT

White Plugs - box of 250 -

Mastic Sealer - 400cc cartridge

 

White Plug before and after fitting mastic rope seal

 
    
    
    
 

 
    
    
White Plug Seal - roll of Mastic Rope - 10mm diameter x 5 metres 
 

For sealing between the white plug head and the dimple in the Membrane. Pieces of mastic rope about 13mm long are cut from the roll and wound under the plug head, to form a circular seal. Usage rate - 1 per plug, 25 per square metre for plastering, 10 per square metre for plasterboard on 'dabs'.

Frequently purchased with this product - Mastic Sealer (400cc tube), for use instead of the mastic rope.

£13.97 per roll, plus VAT

.

 
 
Mastic Rope Seal - on the roll - cut off lengths about 20mm long, wrap around the plug head.
 
    
    
 
 
Tape for joining Membranes - double sided, self amalgamating - 28mm wide x 22.5m  
    
 

For sealing between the sheets of Membrane or Mesh Membrane. Usage rate - allow one roll of tape per 20 square metres of Membrane or Mesh Membrane. It can also be used for patching holes, or sealing other plastic or smooth metal parts through or to the Membrane.

Frequently purchased with this product - Mastic Sealer (400cc tube), for sealing holes drilled through the Membrane that will not take a plug.

£39.73 per 28mm x 22.5metre roll, plus VAT

.

 
  
Mastic Tape - double sided - for joining Memrane Sheets
 
    
    
 
 
Corner Tape for joining Floor and Wall Membranes - single sided - 150mm x 12m
  
 

For sealing 'outside' corners between the sheets of Membrane. Very useful for awkward joins, edges and around pipes and wires. Only sticky on one side. Usage rate - allow one roll 150mm wide x 12 metres long of corner tape per Project. It can be cut down, in width and used for patching holes, or sealing other plastic or smooth metal parts through or to the Membrane.

 

 
 £43.74 per 150mm x 12 metre roll, plus VAT
 
  
Corner Tape on the roll - single sided adhesive.
 
    
 
 
SDS+ Masonry Bit, 8mm and 10mm diameter x 280mm overall  
 For drilling holes in walls to take the White Mesh Membrane Plug or the Black Membrane Plug. Fits standard and SDS+ chucks. Usage rate - allow 2 bits per roll of Membrane or Mesh Membrane.
 
 £8.96 - 8mm diameter, £9.33 - 10mm diameter, plus VAT
8mm or 10mm Diameter Masonry Bit
 
    
 

8mm diameter -

10mm diameter -

  
 
 
Sumps - Black or Yellow (heavy duty) - with a single pump in each   
    
 

Black Sump Kit - a black plastic sump bucket, 560mm high x 460mm diameter (widest), supplied with a composite screw down lid and seal. Includes a powerful pump incorporating float switch, for automatic on/off control. The pump is complete with the pipe adapters and couplings to reach the outside of the sump bucket, to which you can connect standard white waste pipework to connect to the nearest drain or grey water pipe.
Yellow Sump Kit - a yellow, heavy duty sump chamber, 580mm high x 600mm diameter (widest), supplied with a heavy duty, galvanised screw down lid and seal. Includes a powerful pump incorporating float switch, for automatic on/off control. The pump is complete with the pipe adapters and couplings to reach the outside of the sump bucket, to which you can connect standard white waste pipework to connect to the nearest drain or grey water pipe. Incorporates an internal ledge on which a back-up pump can be located

 

 
 £552.63 Black Sump Kit, or £695.00 Yellow Sump Kit, plus VAT
Black Sump Kit and Yellow Sump Kit
 
    
 

- Black Sump Kit

- Heavy Duty Yellow Sump Kit, plus VAT

  
 

    
Pumps - additional, for back-up, to fit Yellow Sump only  
    
 

An additional pump for fitting inside the Yellow Sump, to provide a back-up in the event of failure of the primary pump. It comes complete with all the pipework internal to the sump and an adapter to connect to standard waste pipework beyond the sump (not supplied).

Frequently purchased with this product - Back-up Battery System (ask us for full details).

 
  
Extra Sump Pump and Pipework
 
 

£270 - pump with fittings, plus VAT

  
    
 Pump with fittings -   
 
 
Aquachannel - perimeter drain, outlets and jetting eyes  
 

Special plastic channel with built in entry holes to collect water from around the perimeter of cellars and basements. Supplied in 2 metre lengths. Join with our Mastic Sealant or Joint Tape.

 

 
 

£24.60 per 2 metres of channel. - £37.50 per drainage outlet. - £38.50 per jetting eye, plus VAT

 

Drainage Aquachannel. Drainage Outlet

For more details go to www.drywallandfloor.co.uk

 
  
 
 

Aquachannel, 2 metre length -

Aquachannel Outlet Fitting -

Aquachannel Jetting Eye -

Aquachannel Jetting Eye

 
 

 
Damp Meter - pin type - essential to test timbers in basements and cellars  
 

Professional Damp Meter with Timber and Masonry digital scales, battery and calibration test facilities.

Tip - ask for our FREE guide Data Sheet which describes how to use Damp Meters and explains the meaning of common patterns of readings. Ring Angela or Andy for Free Help on 01626 331351.

For more Meters Click Here.

 

 
 £49.56 plus VAT
Damp Meter testing wood
 
    
 Damp Meter -   
 

 
Hygrometer - measures air temperature and moisture content - essential monitor  
 Handy Hygrometer for measuring Relative Humidity and Air Temperature. This allows you to prevent Mould growth by either regulating the heating and ventilation, or by adjusting your Dehumidifier. A vital tool for assessing the risk of Condensation.
 
 £16.95 Standard Readout £19.96 Jumbo Readout, plus VAT
Jumbo Readout Hygrometer
 
    
  Standard Readout, or Jumbo Readout   


 
  
We accept the following cards: Maestro, Visa, MasterCard
   
   
SECURE PROCESSING
   

Property Repair Systems, Unit 3, Olympus Business Park, Kingsteignton Road, Newton Abbot, Devon. TQ12 2SN

Tel: 01626 331351 Fax: 01626 331143 E Mail: help@propertyrepairsystems.co.uk

   
Home | Damp| Plastering | Membrane | Damp Meters | Anti-Mould Additives |Privacy Policy| Returns Policy | FAQ | Contact